Herkules Hebetechnik GmbH HLS 1200-11, Operating Manual And Test Record

Page: 15 / 44

I
NSTALLATION AND
A
SSEMBLY
15
7 Installation and Assembly
The following important safety instructions must be observed during the assembly of the service lift. Adhering
to safety instructions helps to avoid life-threatening injuries, personal damages, as well as damage to
machinery.

The installation work must only be performed by suitably-trained persons and with compliance of the
safety instructions during the process.

Before commencing the installation work, the lifting platform must be investigated for damage in
transit.

Always ensure that only authorised persons enter the working space and that no other persons are
exposed to any risk from the installation work.

All machine connections (tubes) are laid out so that there is no risk of stumbling.

Also read the C hapter
“
General Safety Instructions
”
.
7.1 Environmental Conditions for Assembly
The service lift is only suitable for use in dry, closed, indoor rooms.
The ground where the car lift is to be assembled should be horizontal and flat (according to DIN 18202), and
the load capacity of the floor must be able to support the total weight of the service lift.
The operator is solely responsible for the selection of the installation location.
The service lift must only be used within a temperature range of 5°C to 65°C. During the selection of the
assembly location bear in mind the measurements of the service lift that are outlined in the chapter
“
Technical Data
”
as well as the chapter
“
Additional Information
”
(take note of the measurements with a
lifted vehicle as well).
Adequate ceiling height must be present (at least the total height of the service lift plus the vehicle height).
Care must be taken that the minimum distances specified are adhered to (according to country-specific
regulations and workplace ordinances) with regard to distance between walls and equipment respectively. It
should be noted that the service lift must not block any emergency escape routes. Adequate lighting must be
present at the assembly site (according to country-specific regulations and workplace ordinances).
A compressed air supply R1/2" of 8 bar mains pressure must be available at the service lift assembly
location.
Care must be taken in selecting the assembly location so that the operator has an
unobstructed view of the service lift and the car being lifted.
Only use dehumidified, non lubricated compressed air! A filter regulator must only be
installed in the mains connection (air filter and water separator)!