Hercules FUTURA COMPACT 10, Translation Of The Original Operating Instructions

Page: 86 / 128

MY21H01 - 22_1.0_30.08.2020
86
Maintenance
8.1.3 Suspension seat post
Only applies to pedelecs with this equipment
Maintenance intervals
Special tools, special lubricants and knowledge of
suspension components are required to service
and repair suspension seat posts.
The suspension seat post may be damaged if
procedures are not followed as described. Only
specialist dealers may carry out maintenance on
the suspension seat post.
8.2 Axle with quick release
by.schulz seat post

Check all screws for correct tightening
torques for:
G1 and G2
After 250 km and
every 1,500 km
Suntour suspension seat post

Maintenance 1
Every 100 hours
RockShox suspension seat post

Venting of remote control lever and/or
maintenance of lower seat post unit for:
Reverb™ A1/A2/B1, Reverb Stealth A1/A2/B1/
C1*, Reverb AXS™ A1*
Every 50 hours

Venting of remote control lever and/or
maintenance of lower seat post unit for:
Reverb B1, Reverb Stealth B1/C1*, Reverb
AXS A1*
Every 200 hours

Complete maintenance of seat post for:
Reverb A1/A2, Reverb Stealth A1/A2
Every 200 hours

Complete maintenance of seat post for:
Reverb B1, Reverb Stealth B1
Every 400 hours

Complete maintenance of seat post for:
Reverb AXS A1*, Reverb Stealth C1*
Every 600 hours
All other suspension seat posts

Maintenance
Every 100 hours
Crash caused by unfastened quick
release
A faulty or incorrectly installed quick release may
become caught in the brake disc and block the
wheel. This will cause a crash.
 Install the front wheel quick release lever on
the opposite side to the brake disc.
Crash caused by faulty or incorrectly
installed quick release
The brake disc becomes very hot during
operation. Parts of the quick release may become
damaged as a result. The quick release comes
loose. This will cause a crash with injuries.

The front wheel quick release lever and the
brake disc must be situated on opposite sides.
Crash caused by incorrectly set clamping
force
Excessively high clamping force will damage the
quick release and cause it to lose its function.
Insufficient clamping force will cause a
detrimental transmission of force. The
suspension fork or the frame may break. This will
cause a crash with injuries.
 Never fasten a quick release using a tool (e.g.
hammer or pliers).
 Only use the clamping lever with the specified
set clamping force.
CAUTION
!