7.4.2 Single Channel Mode – Automatic Channel Recognition
Your Herbert can automatically recognize the pedal’s send/receive
channel. To get your amp into the mood (or mode) for this, push and
hold “Mute” and then activate any program change button on your
MIDI pedal. The amp will look for a program change and recognize the
channel it is being sent on. Then it will switch to this channel and stay
there as soon as you let go of “Mute”.
7.4.3 Single Channel Mode – Manual Channel Selection
If you would like to have your Herbert on a certain MIDI channel,
then we can accommodate you here as well. Here is how this works:
Push and hold “Mute” and then turn on the preamp channels in the
order that corresponds to your midi channel preference. For example:
if you want to have your Herbert to respond only to MIDI information
that is being sent on channel 7, then you must hold the “Mute” button
down and turn the Preamp channel one selector off, channel two
selector on, channel 3 selector on. If you let go of “Mute” now, then
your Herbert is set to respond to MIDI channel 7 only. Get it? The table
below gives you the sequence for all 7 MIDI channels.
Ch.1 off off offCh.2 on off offCh.3 off on offCh.4 on on offCh.5 off off
onCh.6 on off onCh.7 off on on
7.5 Program Information
Herbert can remember up to 128 program changes.
7.6 Phantom Power
Several of the pins in the MIDI jack can supply phantom power to
your MIDI pedal, as explained in chapter 3.3.1
