TRANSMISSION GEARS LUBRICATION
The transmission gears in the gear case need to be lubricated periodically with
gear grease.Check the gear case grease lever approximately every 50hours of
operation by removing the sealing screw on the gear case.There are three sealing
screws:one on the side and two on the top.
If no grease can be seen on the flanks of the gear,follow the steps below to fill
with gear grease to 3/4capacity.
Do not completely fill the transmission gears.
1.
Depending on which screw you are removing, lay the extended-reach hedge
trimmer on its back or hold it on its side so that the sealing screw to be removed is
facing upwards(Fig.P&Q).
2.
Use the dual-head wrench to loosen and remove the sealing screw.
3.
Use a grease gun(not included)to inject some grease into the screw hole;do not
exceed3/4capacity.
4.
Tighten the sealing screw after injection.
Screw
holes
Screw holes
Summary of Contents for NUMBERAS-GZJ20
