HENX HSX1420, Owner'S Manual

Page: 17 / 30

17/30
Intended use
This product is intended for clearing
garden paths, yards and private
approach lanes from snow in domestic
areas. The product may not be used on
high plateaus like roof gardens.
For safety reasons it is essential to read
the entire instruction manual before first
operation and to observe all the
instructions therein.
This product is intended for private
domestic use only, not for any
commercial trade use. It must not be
used for any purposes other than those
described.
Clearing snow
WARNING! Foreign objects,
such as rocks, broken glass,
nails, wire, or string, can be
picked up and thrown by the
product, causing damage and serious
personal injury! Ensure that no hidden
objects are covered by the snow!
Remove all foreign objects from the
area to be cleared before operating the
product!
1.
Keep the area of operation free of
foreign objects that can become
thrown by the auger. Perform a
thorough inspection of the area since
some objects may be hidden from view
by surrounding snow. If the product
hits an obstruction or picks up a foreign
object during use, stop the product,
switch off and disconnect from the
power supply, remove the obstruction,
and inspect the product for damage.
Repair or replace any damaged part
before restarting and operating the
product.
2.
Keep children, pets, and bystanders
away from the area of operation. Be
aware that the normal noise of the
product when turned on may make it
difficult for you to hear approaching
people.
3.
Pay attention to the wind direction. If
possible, move in the same direction
as the wind so that the snow is not
thrown against the wind (and thus
back into your face and on the just
cleared path).
4.
Do not push the product with
excessive force. You should push the
product gently and evenly in
accordance with the products throw
rate.
5.
Some parts of the product may freeze
under extreme temperature conditions.
Do not attempt to operate the product
with frozen parts. If the parts freeze
while the product is in use, stop the
product, switch off and disconnect
from the power supply, and inspect for
frozen parts. Free all parts before
restarting or operating the product.
Never force controls that are frozen.
Adjust discharge direction
and distance
Adjust the discharge direction in vertical
and horizontal position before each use.
The proper direction depends among
others on the snow condition and
working area.
If the deflector is in a lower position the
snow is thrown in a short distance; if the
deflector is in an upper position the
snow is thrown farther.