21/30
Removing blockages
WARNING! Wear protective
gloves when removing
blockages! Use proper tools
to remove debris, e. g. a
wooden stick! Never use
your bare hands!
Warning! Rotating working
tool, keep hands away! Do not insert
your hands into the discharge chute.
1.
Check the discharge chute for
blockages and use the shovel to
remove any.
2.
Check the auger and remove possible
clogging with the shovel, brush or
blunt tool. Check to make sure the
auger is in an undamaged condition.
Contact an authorised service centre if
parts are damaged and a replacement
is necessary.
Auger
WARNING! Wear protective
gloves when working on
the auger to avoid injuries!
WARNING! Wait until all moving parts
have come to a complete stop before
touching them. Auger continues to
rotate after the product is switched
off.
1.
Remove snow from the auger after
use using a proper brush or tool.
2.
Check for any damage and wear.
Have the auger replaced by a qualified
specialist if it is bent, damaged or worn.
Otherwise the performance and safety
of the product cannot be guaranteed
.
Auger Replacement
1.
Loosen the 4pcs bolts and nuts by
wrench. Replace the old rubber auger with
new one. Then, securely retighten bolts
and nuts.
Scraper
1.
The scraper is located at the base of
the product beneath the guard.
2.
Detach and remove the worn scraper
from the product by removing the
three bolts as photo.
3. Install the new scraper and fasten it
securely to the guard with the bolts nuts
in reverse order.
IMPORTANT:
DO NOT
allow Scraper too
wear to far or Auger housing will become
damaged.
Summary of Contents for HSX1420
Page 26: ...26 30 EXPLODED VIEW ...
Page 27: ...27 30 ...
