HENX H36DCG120A01, Original Instruction

Page: 22 / 33

guard must always be on the tool to protect the user.
WARNING: When the tool is equipped with a
trimmer head, the guard accessory
with line–cutting blade should be mounted onto the guard. Failure to comply will
result in overly long cutting line and overload the motor. Never use the trimmer
head without guard accessory.
ASSEMBLY
WARNING: If any parts are damaged or missing, do not operate the brush
cutter until the parts are replaced.Use of the brush cutter with damaged or missing
parts could result in serious personal injury.
WARNING: Do not attempt to modify the brush cutter or create accessories not
recommended for use with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading to possibly
serious personal injury.
WARNING: Always wear heavy gloves when installing or removing the guard
and doing any maintenance on the 3-teeth blade/line-cutting blade. Be careful of
the line-cutting blade on the guard accessory/3-teeth blade for protecting your
hands from being injured by both the blades.
WARNING: To prevent accidental starting that could cause serious personal
injury
，
always remove the battery pack from the
pack from the tool when assembling parts or transporting the machine.
WARNING: Never operate the tool without the guard and bike handle firmly in
place. Failure to comply could result in possible serious personal injury.
MOUNTING AND ADJUSTING THE BIKE HANDLE
The brush cutter is stored as shown in Fig. B. Firstly, loosen the wing bolt on the
connecting joint and then lift the bike handle 180° around the shaft (Fig. C),
turn it 90°anticlockwise to make it face the bump head (Fig. D).Lastly, move it back
and forth to achieve a comfortable working position and tighten the bolt.
NOTICE: operating the machine with the bike handle perpendicular to the shaft is
only permitted.