1
Install guide plate and chain
：
---
Before inserting the battery pack into the tool, be sure to check that the trigger and
self-locking button spring back up.
In order to avoid the user accidentally pull the trigger of the switch, this tool adopts the
self-locking button!
To start the tool:
First, pull the front baffle from position (1) to position (1-1), then
press the self-locking button and pull the trigger of the switch.
Release the trigger switch and the tool will stop immediately or push the front damper
from the position (1-1) to the position (1) in the picture and the tool will stop immediately.
D) Guide plate/chain assembly
Notice
：
---
Before performing any assembly operation on the tool, be sure to turn off the tool
power and remove the battery pack.
---
Gloves must be worn before installation or removal.
Step 1 :(as shown in figure 1) place the chain guide tooth into the groove of the guide plate
to locate the whole chain. Note that the cutting teeth (cutting edge) on the chain are facing
the front end of the guide plate;
Step 2 :(as shown in figure 2) put one end of the guide plate and the chain in the state
shown in figure 1 into the sprocket, and place the guide plate on the mounting plane.
Pretension the guide plate and the chain according to the arrow direction shown in the
figure;
