SBS-800 Series Operator & Planned Maintenance Handbook
Chapter 2
: Health and Safety Warnings
KH-1601-2 Issue 6
Page 10 of 80
ANTENNA LIFTING
Care should be taken when unpacking or lifting antennas to ensure that the waveguide is not bent, crushed or damaged
during handling.
Support the antenna near the ends when lifting it out of the packing and when fitting into position on the turning
mechanism.
Do not lift, handle or support the antenna by the waveguide.
When rotating an installed antenna by hand, do not apply excessive force.
The antenna and antenna facia must never be painted or have non-approved labels attached.
CAUTION
During installation, the antenna must be secured and supported at all times to prevent any risk of falling or slipping. Antennas
must never be left unsupported on the swing casting.
CORRECT & INCORRECT LIFTING PROCEDURES
Example of CORRECT lifting procedure
Examples of INCORRECT lifting procedure
Illustration note
: The above drawings are shown for reference use only and may not represent the actual equipment
supplied as part of an SBS series.
CAUTION
Equipment should only be installed and operated when all welding, grinding, sanding etc. within the installation area has been
completed. All equipment is to be installed in a clean environment that is free from grinding dust, welding spatter, shot blast,
moisture, excessive dust etc. Where this is not possible, then the equipment is to be protected to prevent dirt and
contamination from work being carried out around the equipment. KH will not be held liable for damage to equipment as a result
of poor environmental conditions encountered pre-commissioning.
Within the warranty period or prior to commissioning, the warranty will be void if the equipment is not correctly installed,
operated or stored, installed or operated in an unsuitable environment. This includes any damage caused by improper transport
and storage.
