Now push the already prepared push rod through the upper hole of the clamp 0809 from behind.
The second support 0808 has to be thread also to the push rod. Later it has to be fasten at the boom with thin dobble side
adhesive tape exactly in a position were the mounted canopy touch the boom. So it will not only support the push rod but also
protect the boom from scratches. Pay attention for the right mounting angle so that the push rod will be positioned in the
middle above the boom.
Screw the push rod at the front in the clevis mounted to the tail servo. Adjust the length of the push rod such that there is a
distance of approx. 6mm between the tail pitch slider and the gear wall at the neutral position of the servo arm.
If you do so there should be also about 6mm at the other side.
The tail blades should have a little angle against the rotor torque in this position (see picture below).
31
