24
B e a r i n g p l a t e p r e p a r a t i o n
(Assembly group 2)
0221
Upper bearing plate
1
0222
Lower bearing plate
1
0223
Radial bearing 12x24x6
2
0206
Mounting block
4
0207
Carbon X stiffening front
1
0208
Carbon X stiffening back
1
L0306
Lense head screw M3x6
6
L0308
Lense head screw M3x8
2
M0306
Hex socket screw M3x6
4
M0308
Hex socket screw M3x8
12
M0312
Hex socket screw M3x12
4
The bearings 12x24x6 for the rotor shaft will be pressed into the
bearing plate until they are aligned with the upper surface. By
heating up the plate the work will become easier.
Three M3x6 lens head screws secure the bearings from sliding
either upwards (lower plate) or downwards (upper plate).
Attention!
The three M3 holes in the plates have a sunk on one
side to allow the head of the screws resting on the plate in any
case. Take care to use the plates in the right direction and
insert the security screws from this side.
The two fixation blocks
0206
used later on for the front X-
stiffener will be screwed from below to the upper bearing plate.
Take care to align the outer edges of the blocks with the outer
edges of the bearing plate while tightening the M3x12 screws.
This can easily be ensured if you place the bearing plate on an
even plate with the outer edge and press it down together with
the block during tightening.