20
The following drawings show midi size servos with a housing width of 15mm. When using standard servos with a width of
20mm the blocks for the aileron servos are just 0,2mm wider on the side with the M3 thread.
E l e v a t o r
s e r v o
– p r e p a r a t i o n
The elevator servo will be screwed to the blocks
0630NS
(three
holes) according to the drawing.
The servo pads are used to get the necessary extensive
pressure on the rubber blocks until the servos are fixed tightly
without play.
Torque the M2,5x16 screws and the 2,5 nuts stepwise and
equally. Take care that the blocks are correctly aligned.
This servo will be mounted at the next assembly step on the
inner side of the right chassis plate.
A i l e r o n s e r v o
– p r e p a r a t i o n
Both aileron servos will be fixed similar to the elevator servo on
the blocks
0630RS
.
Take care of the positioning of the M3 thread holes at the front
side which shall be facing to the left and the right outside.
These servos will be mounted later on in the inner side of the
left and right chassis plate.
T a i l s e r v o
– p r e p a r a t i o n
In difference to the swash plate servos the tail servo will be
mounted with the upper side of the servo flanges to the servo
blocks
0630HS.
The servo lever will be mounted according to the drawing and
equipped with one ball pin
0638
. The length of the lever should
be about 13mm.
The remaining M3x6 and M3 washers will be used to mount the
servos to the chassis plates (see chapter 4).