Henny Penny HC 900, Service Manual

Page: 22 / 66

Henny Penny Model HC-900
3-7. OPERATING CONTROLS Timer Regulation - All timers can be set to a different starting time.
900 and 903 CDT
(if applicable)
1. Press and hold the PROGRAM button.
(Continued)
2. The control beeps and “Prog Enter Code” shows in display.
3. Enter access code 1, 2, 3.
4. Press the PROGRAM button, and “---” is displayed, along with
all the timer settings.
5. Press the desired timer and the starting time flashes.
6. Press the INCREASE and DECREASE buttons to change the
starting time.
7. Press the timer button to set the new starting time, and now a
different timer button can pressed, and it changed.
8. When finished setting timers, press and hold the PROGRAM
button to exit programming.
NOTE
Exit the program mode at any time by pressing and holding the
PROGRAM button. Also, if no buttons are pressed for two
minutes, programming is exited automatically.
Timing Through Power Down
If a power failure occurs while a timer, or timers are running, the
controls will continue to count down even though the unit has no
power going to it. Once the power comes back on, the timers will
show the correct time remaining and will not have to be reset.
3-8 401