12
Operation details: user move the cursor to “Alarming mode”, press
“ok”, by “
▲” or “
▼”
can change the alarming mode, after switch then
press “ok” will save the setting.
6.2.7 Detection storage
With this function user can set the detecting mode, storage mode,
print mode, the detecting mode including the realtime detecting and timing
detecting, storage mode including the manual save , auto save and
close(not save), print mode including hand, auto, close.
If realtime detecting, the detector will display the realtime
concentration of each channel, then user can set the storage mode and print
mode, also can set the storage and print cycle. If timing detecting mode,
will display and print the average concentration is this period, can set the
timing cycle and round cycle(time between the twice timing detecting).
Setting the timing detection, need to back to the Detecting interface to
press the “Run/stop”key, turn on the countdown to begin timing detection,
if not turn on the round detecting, when the countdown over, the detector
will stop pump detecting automaticly; if turn on the round detection, after
several seconds, it will begin the timing detecting again automaticly.
6.2.8 Date
Setting the date related with the detecting gas concentration data.
6.2.9 Factory reset
Once mistake operation, user can use this function to recover the
initial configuration.
7.Remarks
◆
Befor use the detector, please read the instruction carefully.
◆
Prohibit open the detector and replace the accessories privately.
◆
Install ,setting must be operated by professional guidance.
◆
Regularly check the device and change the sensor.
