1.
Assemble the piano near a wall power outlet.
2.
Proceed according to the illustrations and exclusively use the supplied screws.
Using other screws could damage the piano housing or result in a reduced sta‐
bility of the piano.
3.
Screw the levelling bolts on the bottom of the pedal box completely in.
Put the pedal box on the angle pieces of the left and right side panel and use
two screws M6
´
20 on each side to affix both side panels to the pedal box.
Then turn the levelling screws on the bottom of the pedal box as far out that
the pedal box is thus supported evenly over the entire length on the ground.
4.
Slide in the rear cover before the small angle pieces and attach the rear cover
with two screws M4
´
12 and washer. Now affix the rear cover with four screws
ST3 9
´
16 and washer to the pedal box.
Mechanical assembly
Assembly instructions
DP-501 MK II
11
