EN-5
4.0
KNOW YOUR WELDER
4.1 QUICK START
Your new single phase inverter multi-function welder offers
THREE WELDING FUNCTIONS
in the same
power source. These functions can be selected with knob (6) on the front panel of the unit:
MIG (GMAW and FCAW) Welding with Gas and without Gas
This welder offers the choice to weld in manual or synergic mode.
1.
Manual Mode: The operator is required to set both the wire speed (Left Knob - 8- ) and the welding
voltage (Right Knob - 7 -).
2.
Synergic Mode: the operator is required to simply set the thickness of the material to be welded (Left
Knob -8-). Once this parameter is set, the synergic function automatically adjusts the wire speed and
the welding voltage allowing the operator to balance this last value simply adjusting the Right Knob (7).
Stick Welding (SMAW)
Both rutile and basic electrodes can be welded. Welding current is adjusted using the Left Knob (8).
TIG welding (GTAW)
In the TIG position, a TIG torch with a gas valve in the handle is required. The gas valve must be opened
manually before welding and closed manually when welding is completed. The arc is activated by scratching
the tip of the electrode. Using the Left Knob (8) welding current can adjusted.
4.2 CONTROLS AND OPERATIONAL FEATURES
4
3
5
13
8
7
6
2
1
11
9
10
16
17
15
18
19
Figure 3
Summary of Contents for TP 195
