TB20, strain gauge weighing module | Edition 1 | 21.12.2018
11
1.6.6
Operation
Operate the TB20 only in flawless condition. The permissible operating conditions and performance
limits must be adhered to. Retrofits, changes, or modifications to the device are strictly forbidden.
The TB20 is a piece of operating equipment intended for use in industrial plants. During operation,
the TB20 can carry dangerous voltages. During operation, all covers on the unit and the installation
must be closed in order to ensure protection against contact.
1.6.7
Liability
The contents of this manual are subject to technical changes resulting from the continuous
development of products of Helmholz GmbH & Co. KG. In the event that this manual contains
technical or clerical errors, we reserve the right to make changes at any time without notice. No claims
for modification of delivered products can be asserted based on the information, illustrations, and
descriptions in this documentation. Beyond the instructions contained in the operating manual, the
applicable national and international standards and regulations must also be observed in any case.
1.6.8
Disclaimer of liability
Helmholz GmbH & Co. KG is not liable for damages if these were caused by use or application of
products that was improper or not as intended.
Helmholz GmbH & Co. KG assumes no liability for any printing errors or other inaccuracies that may
appear in the operating manual, unless there are serious errors of which Helmholz GmbH & Co. KG
was already demonstrably aware.
Beyond the instructions contained in the operating manual, the applicable national and
international standards and regulations also must be observed in any case.
Helmholz GmbH & Co. KG is not liable for damage caused by software that is running on the user’s
equipment which compromises, damages, or infects additional equipment or processes through the
teleservicing connection, and which triggers or permits unwanted data transfer.
1.6.9
Warranty
Report any defects to the manufacturer immediately after discovery of the defect.
The warranty is not valid in case of:
Failure to observe these operating instructions
Use of the device that is not as intended
Improper work on and with the device
Operating errors
Unauthorized modifications to the device
The agreements met upon contract conclusion under “General Terms and Conditions of Helmholz
GmbH & Co. KG” apply.
