HELIX HLT3000, Assembly Manual

Page: 7 / 24

3/ ASSEMBLY
- 7 -
Step 1:
Put the product on the floor and remove the top box cover to reveal the
Helix as show above. Where the box corners are printed “OPEN”, cut or tear
the box and separate these corners. Lay the sides flat to the floor
Remove all parts from the box leaving just the main body of the
machine on the bottom of the box. remove all parts from their
plastic bags and organize on the floor beside the Helix.
Step 2:
Attach the End Caps (with HELIX branding ) to the left and right stabilizers.
The branded end caps install on the end farthest from the attaching bolt
holes. Attach Rear End caps (no branding) to the left and right stabilizers at
the end closes to the attaching bolt holes. They are front and rear specific
but not left and right specific. Install the stabilizer adjustment feet (4) into
the bottom of the stabilizers and adjust as required.
IMPORTANT:
Do not remove the
Helix from the box
bottom until further
instructed later in
this assembly
manual.
A5-HLT3500.indd 7 14/12/2012 19:48