22
In regions where heavy winds, typhoons,
hurricanes and storms are usual, it is
necessary to use the special
TYPHOON
SET
, provided by
HELIOAKMI
.
The
TYPHOON SET
contains:
1. Plates (J) of 1150mm
2. Plates (D) of 930 mm
3. Short fixing plates (L)
4. Long screws - small step nuts
5. Tape of metal belt.
6. Rubber profile
7. Moly plugs - screw nuts
Before you start installing the appliance,
you should check the following:
• For installation on a flat surface, check
the density, hardness and strength of
the concrete.
• For installation on a sloping roof, addi
-
tional rafters must be installed under the
tiles, so that the distance between the
rafters doesn’t exceed 50 cm, and their
strength must be good enough for the
safe installation of the appliance.
Special climatic conditions
To assemble the support base
follow the same assembly procedures,
mentioned on pages
9-10 and 11-12 (for flat
or sloping surfaces).
For the connection of
the plates U, Z and B,
use the long
screws -
small step nuts.
Before you adjust
the metal belts around
the storage tank, place
the rubber profile
between the storage
tank and the metal
belt.
After you have placed
the storage tank on the
support base, adjust
the metal belt connec
-
ting the one end of the belt between the
screw-nuts, which tighten the plates U
and Z and the other end of the metal belt
between the screw-nuts which tighten
the plates U and B. (see detail a & b).
attention
Use the second nuts (O) to tighten the
metal belts. Tighten well the metal belts
on the storage tank.
ASSEMBLING INSTRUCTIONS
J
U
B
J
C
a
U
Z
O
D
J
L
b
U
B
O
