15
®
TROUBLESHOOTING
TROUBLESHOOTING
PROBLEM:
230Si does not react to any stick movements.
Solution 1:
Make sure that the battery voltage is above 4.0 volts
Solution 2:
If the LED on the rear of the model is not steady, unplug the
battery and turn off the transmitter to allow the control board to reset itself.
After about a minute, turn on the transmitter and reconnect the battery.
PROBLEM:
230Si responds to the controls, but barely moves left or right.
Solution:
Adjust the control sensitivity as described in the Flight Control
Sensitivity section.
PROBLEM:
Flies with poor power or buzzes.
Solution:
One of the props may be bent. Carefully bend it straight.
PROBLEM:
The 230Si will not return directly to you in Return to Pilot mode.
Solution:
Calibrate the control board sensors as described in the System
Adjustments section.
PROBLEM:
The 230Si is always drifting off in the same direction.
Solution:
Trim the quadcopter as described in the System Adjustments
section.
STATUS LED CODES
THIS SIGNAL
MEANS THAT THE
1 Long, 3 Short, Off, 1 Long,3 Short …
Steady
1 Short, Off (moderately flashing)
1 Long, Off (slowly flashing)
3 Short, Off, Remains ON
3 Short, Off, 1 Short, Remains On
3 Short, Off, 2 Short, Remains On
1 Short, Off (rapidly flashing)
Control board not linked with transmitter
230Si ready for flight
Auto Return mode is active
Actual Direction Control mode is active
230Si is in the Limited Altitude throttle setting
230Si is in the Altitude Hold throttle setting
230Si is in the Normal throttle setting
Battery is low, land as soon as possible
PROBLEM:
The Camera System will not take a photo or record a video.
Solution 1:
Install the microSD card if it is not in the slot.
Solution 2:
Eject the card and check for any debris on the contacts.
Solution 3:
Make sure card is OK by putting the card in reader and
checking on your PC.
