H. Vollmer GmbH
ǀ
Allmendring 29
ǀ
75203 Königsbach-Stein
ǀ
www.HEITRONIC.de 3 / 8 11/21
GB Installation and operating instructions
LED Battery Table Lantern Tessera
Art. No. 501228
These operating instructions belong exclusively to the product. It contains important information on
the commissioning and handling of the light. Therefore, please pay attention to these operating
instructions, even if you pass this product on to third parties.
Please keep these instructions in a safe
place for future reference.
1. Introduction
Dear customer, thank you for purchasing our product. You have purchased a product from Vollmer,
which has been built according to the current state of the art. The luminaire meets the requirements of
the applicable European and national directives. In order to maintain the condition of the product and
to ensure safe operation, you as the user must observe these operating instructions!
2. Safety instructions
In case of damage caused by non-observance of these operating instructions,
the warranty claim expires!
We do not assume any liability for consequential damages!
Do not bring the lamp into contact with extreme heat or open flame.
We accept no liability for damage to property or personal injury caused by improper handling or
non-observance of the safety instructions.
In such cases, all warranty claims are void.
The entire product must not be modified or converted. Modifications to the product will void the
warranty.
The type plate must not be removed.
3. Intended use
The luminaire is designed for indoor use.
Make sure that the lamp is always standing
level on the ground to prevent it from falling
over.
The head of the lamp is connected to the
base via a magnet. This allows the discus
to be removed and used separately.
Please make sure that no liquids get on
the luminous surfaces.
4. Start-up and running time
Carefully remove the lamp from its packaging.
Pull the isolation flag out of the battery compartment,
to ensure proper function.
There is no possibility to change the illuminant
There is no possibility to change the battery
The type plate must not be removed.
Charge the lamp (see point 6 Charging the lamp and
runtime).
Turn the luminaire on and off by touching the touch sensor
switch on the top of the luminaire. The luminaire can also
be dimmed continuously by touching the touch sensor
switch.
