2 of 5 | Dated 10.05.2016
6. Connect the connector plug on the LED strip with the controller connection socket.
7. Insert the power pack plug into the controller connection socket.
8. Insert the power pack mains plug into the power socket.
9. The LED strip can be shortened to your ideal length if
required. Cut off the strip on the copper coloured
connection using a pair of scissors.
Note:
Please note that after shortening the LED strip the protection type is not provided any longer at this point!
The point of separation must be sealed with silicone/shrink wrap to achieve the original protection type
again.
5. Faulty Function
LED strip does not switch on
The LED strip has one direction of flow - check the connection of the distributor to the LED strip.
LED strip connected with the power supply?
Remote control does not work.
Battery inserted correctly? Check the poles.
Battery low or defective. Replacing the battery
Sensor within range? Reduce the distance to the sensor.
6. Replacing the Batteries
Open the battery compartment cover on the underside of the remote control and insert the batteries.
Pay attention to the correct polarity of batteries as shown in the housing (Size +/-).
Close the battery compartment after inserting the batteries.
7. Technical Data
Article Quantity
Description
Connection/power
Protection
Level
Protection
Class
38037
LED strip set RGB+WW
1
LED driver with connection
cable
Input: 230 V AC,
Output: 12 V DC, max. 2 A
IP20
II
1
LED strip, L = 5000 mm,
RGB+WW
LED, RGB+WW, 12 V DC, 24 W,
LED lamp not replaceable
IP20
III
1
RGB remote control
1 lithium battery 3 V, type CR 2025
IP20
III
1
RGB receiver
12 V DC
IP20
III
8. Care
Please use a lightly moistened cloth to clean.
Never use chemicals or scouring agents for cleaning.
