Heinner HEM-250, User Manual, Page: 20 / 56

www.heinner.com 1050W, 50-60Hz, 220-240V
19
V. USING INSTRUCTION

Before first use:
To ensure the first cup of coffee tastes excellent, you should rinse the coffee maker with
warm water as following:
1. Pull out the water tank at the right side of the coffee maker . Pour water into water
tank, the water level should not exceed the “MAX” mark in the tank. Put the water
pipe into the water tank then insert it into the coffee maker.
Note: the appliance is supplied with a removable tank for easy cleaning, you can fill the tank
with water firstly, and then insert the tank into the appliance.
2. Set steel mesh into metal funnel (no coffee in steel mesh), then insert the funnel into
the appliance from the “Insert” position, and you can fix them into coffee maker
firmly by turning it anticlockwise until it is at the “Lock” position.
3. Place an espresso cup you have prepared on removable cup shelf. Make sure the
steam control knob is at the minimum position.
Note: As the appliance is not equipped with any cup or jug, prepare a your own jug or cup.
4. Connect into power source, press down the ON/OFF button to the lower position
which is the “ ” position. The power indicator (orange) will be illuminated.
5. Press down the pump control button to the lower position which is the “ ”
position, the pump will pump water, when there is water flowing out and close the
pump by pressing the pump control button again to the “
STO P
” position.
6. Make sure the coffee/steam button is on the higher position which is the
position and wait for a moment, the appliance begins to be pre-heated until the
coffee/steam indicator (green) illuminate, it means that the pre-heating is finished.
7. Press the pump to the lower position which is the “ ” position again, and water will
flow out.
8. After water has flown for 1 minute, press the pump control knob to “
STO P
” position,
you can pour out the water in each container then clean them thoroughly, now you
can start brewing coffee.