6
Machine positioning
When positioning the machine, place it in an area where dishes can be easily loaded and
unloaded. Do not put the machine in an area where the ambient temperature falls below 0°C.
Read all warnings located on the packaging before removing the packaging and positioning the
machine.
Place the machine close to a water tap and drain. Take into consideration that the connections
will not be altered once the machine is in position.
Do not hold the machine by its door or panel.
Leave an adequate distance around the machine to allow ease of movement when cleaning.
Ensure the water inlet and outlet hoses are not squeezed or trapped and that the machine
does not stand on the electrical cable while positioning.Adjust the feet so the machine is level
and balanced. The machine should be placed on flat ground otherwise it will be unstable and
the door of the machine will not close properly.
Water connection
We recommend fitting a filter to your water inlet supply in order to prevent damage to your
machine due to contamination (sand, rust, etc.) from indoor plumbing. This will also help
prevent yellowing and deposit formation after washing.
Water inlet hose
WARNING:
Use the new water inlet hose supplied with your machine, do not use an old
machine’s hose.
WARNING:
Run water through the new hose before connecting.
WARNING:
Connect the hose directly to the water inlet tap. The pressure supplied by the
tap should be a minimum of 0.03 MPa and a maximum of 1 MPa. If the pressure exceeds 1
MPa, a pressure relief valve must be fitted between the connection.
WARNING:
After the connections are made, turn the tap on fully and check for water leaks.
Always turn off the water inlet tap after a wash program has finished.
An Aquastop water spout is available with some models. Do not damage it or allow it to
become kinked or twisted.
V.
INSTALLATION
