7
Water outlet hose
The water drain hose can be connected either directly to the water drain hole or to the sink
outlet spigot. Using a special bent pipe (if available), the water can be drained directly into the
sink via hooking the bent pipe over the edge of the sink. This connection should be at a
minimum of 50 cm and at a maximum of 110 cm from the floor plane.
Warning: When a drain hose longer than 4 m is used, the dishes might remain dirty. In that
case, our company will not accept responsibility.
Electrical connection
The earthed plug of your machine should be connected to an earthed outlet supplied by
suitable voltage and current. If there is no earthing installation, have a competent electrician
carry out an earthing installation. In case of usage without earthing installed, our company will
not be responsible for any loss of usage that might occur.
The indoor fuse current value should be 10-16 A.
Your machine is set according to 220-240 V. If the mains voltage in your location is 110 V,
connect a transformer of 110/220 V and 3000 W inbetween. The machine should not be
plugged in during positioning.
Always use the coated plug supplied with your machine. Running in low voltage will cause a
decline in washing quality. The machine’s electrical cable should be replaced by an
authorised service or an authorised electrician only. Failure to do so may lead to accidents.
For safety purposes, always make sure to disconnect the plug when a wash programme is
finished.
In order not to cause an electric shock, do not unplug when your hands are wet.
When disconnecting your machine from the mains supply, always pull from the plug. Never pull
the cord itself.
Summary of Contents for HDW-BI4582TA++
Page 42: ...www heinner com 41...
