6
Machine positioning
When positioning the machine, place it in an area where dishes can be easily loaded
and unloaded. Do not put the machine in an area where the ambient temperature falls
below 0°C.
Read all warnings located on the packaging before removing the packaging and
positioning the machine.
Place the machine close to a water tap and drain. Take into consideration that the connections
will not be altered once the machine is in position.
Do not hold the machine by its door or panel.
Leave an adequate distance around the machine to allow ease of movement when
cleaning.
Ensure the water inlet and outlet hoses are not squeezed or trapped and that the
machine does not stand on the electrical cable while positioning.
Adjust the feet so the machine is level and balanced. The machine should be placed on
flat ground otherwise it will be unstable and the door of the machine will not close
properly.
Water connection
We recommend fitting a filter to your water inlet supply in order to prevent damage to your
machine due to contamination (sand, rust, etc.) from indoor plumbing. This will also help
prevent yellowing and deposit formation after washing.
Water inlet hose
WARNING: Use the new water inlet hose supplied with your machine, do not use an old
machine’s hose.
WARNING: Run water through the new hose before connecting.
WARNING: Connect the hose directly to the water inlet tap. The pressure supplied by the tap
should be a minimum of 0.03 MPa and a maximum of 1 MPa. If the pressure exceeds 1 MPa, a
pressure relief valve must be fitted between the connection.
WARNING: After the connections are made, turn the tap on fully and check for water leaks.
Always turn off the water inlet tap after a wash program has finished.
An Aquastop water spout is available. Do not damage it or allow it to become kinked or twisted.
V.
INSTALLATION
