Heinner HCH-490-BK, Instruction Manual

Page: 12 / 58

www.heinner.com 2x60W, 50Hz, 220-240V
11
INSTALLING GREASE MESH FILTERS
To install filters for the following four steps:
•
Angle the filter into the slots at the back of the hood.
•
Push the button on the handle of the filter.
•
Release the handle once the filter fits into a resting position.
•
Repeat to install all filters.
CARBON FILTER (not included in the package)
Activated carbon filter can be used to trap odors. Normally the activated carbon filter
should be changed every 3 to 6 months according to your cooking habits. The installation
procedure of activated carbon filter is as below:
1. Before installing or replacing the carbon filters, disconnect the mains power to the
unit.
2. Press the filter lock and remove the mesh filter.
3. Turn the carbon filter on both side of the motor anti-clockwise. Replace the carbon
filters with the new carbon filters.
4. Place the mesh filter.
5. Connect the power supply to the wall socket.
Note:
•
Make sure the filter is securely locked. Otherwise, it would loosen and cause
danger.
•
When activated carbon filter attached, the suction power will be lowered.
BULB REPLACEMENT
•
The bulb must be replaced by the authorized service or similarly qualified
persons.
•
Always switch off the electricity supply before carrying out any operations on the
appliance. When handling bulb, make sure it has completely cooled down before
any direct contact with hands.
•
When handling bulbs hold with a cloth or gloves to ensure perspiration does not
come in contact with the bulb as this can reduce the life of the bulb.