Heidolph Hei-VAP Expert, Operating Manual

Page: 15 / 200

Device Description
15
Start-up Setting up the device
Warning:
Risk of slipping for the device!
Due to an unsuitable surface or as a result of vibrations generated
during the operation the device may tilt or start moving and slide off
the table top.
The installation surface must be smooth, level, clean and temperature
resistant. Avoid shaking and impact forces on the device as well as at
the installation surface.
➜ Set up the device on a solid, smooth, level and temperature-resistant surface.
➜ Clean installation surface and feet off the device with a damp cloth and ethanol
regularly.
Connecting/disconnecting the power cord
Connecting the power cord
The power cord has a three-pole connector
and a recess on its bottom side.
Power cord connector Power cord
The device socket is located on the back
side of the device.
➜ Insert the power cord connector into
the device socket with the recess
pointing downwards.
✓ The connector has been securely
inserted when it has been pushed in up
to the stop.
➜ Now insert the power cord plug into the
power socket.
Device socket
Disconnecting the power cord
➜ First, remove the plug from the power socket.
➜ Then disconnect the power cord connector from the device.
Remove transportation lock
Caution:
Possible damage to the device (motor lift variants only)
Switching the device on before the heating bath and the control panel
are connected can cause malfunctioning of the electronics the moment
the transportation lock is removed.
Prior to switching on the device for the first time, remove the transpor -
tation lock exactly in the order given in the instructions (see chapter
“Assembly”, section “Transportation lock”).