HEIDELBERG e.GO Wallbox home, Installation Instructions Manual

Page: 18 / 60

able/enable device. These lines must also be fed
into the column from below.
1
2
ST.000.0002-000GRAUND_00
Fig. 3 Grounding point of the column
5. Attach a cable protecting sleeve (separate parts
set) to the cable outlet opening (Fig. 3/2).
6. Feed the connecting line and, if appropriate, the
lines for an external enable/disable device out of
the cable outlet opening of the column.
7. Fasten the column to the foundation using the 4
screws.
8. Connect the equipotential bonding line to the
grounding pin (Fig. 3/1) of the column.
●
Sequence: contact disk, washer, cable lug/
cable, washer, spring ring, nut.
● Tightening torque 12 Nm.
1.7 Installation of the column if the connecting line is routed above ground
1
ST.000.0003-000GRAUND_00
Fig. 4 Base plate of the column
1. Position the column at the desired installation lo‐
cation.
2. Mark the four bore holes on the foundation using
the column's base plate (Fig. 4/1) as a template.
3. Drill the four mounting holes (diameter according
to the heavy-duty dowels being used).
4. Route the connecting line(s) in a cable conduit/
cable duct to the desired installation position.
Note
Route the connecting line to the column
so that it is not a tripping hazard.
1
ST.000.0007-000GRAUND_00
Fig. 5 Cable entry into the column
5. Attach a cable protecting sleeve (separate parts
set) to the cable entry opening (Fig. 5/1).
6. Feed the connecting line into the column through
the cable entry.
If the cable is particularly rigid, it is easier to feed
in the connecting line when the column is hori‐
zontal.
If equipotential bonding of the column is required,
a separate equipotential bonding line must be
routed to the column. This also applies to addi‐
tional lines required for an optional external dis‐
able/enable device. These lines must also be fed
through the cable entry (Fig. 5/1).
Installation instructions
A.1.4