HEC AS09TB1HRH, User Manual

Page: 3 / 8

CONTROLLER FEATURES & SETTINGS PAGE 3
ENGLISH
10 Timer Button
ON-OFFO peration
1.Status displa y of air flow
When restart after remote turning off, the remote
return to the previous
2.Left and right air flow adjustment
Cautions:
When adjusting the flap by hand,turn off the unit.
When humidity is high,condensate water might occur
It is advisable not to keep horizontal flap at downward
position for a long time in COOLor DRY mode ,
otherwise, condensate water might occur.
at air outlet if all vertical louvers are adjusted to left or
right.
controller will automatically
Note:
set swing position.
Press button to enter additional options, when
cycle display to , will flash. And then press
enter to Left and right air flow function.
(This function is unavailable on this 5 models.)
COOL/DRY:
HEAT:
Initial state
Press button to enter additional options, when
cycle display to , will flash. And then press
enter to up and down air flow function.
Press button. For each press,changes as follows:
Remote controller:
Press button. For each press,changes as follows:
Remote controller:
COOL/DRY/HEAT:
1.After unit starts, select your desired operation mode.
2.Press TIMER button to change TIMER mode. Every
time the button is pressed, display changes as follows:
Remote controller:
Then select your desired TIMER mode (TIMER ON or
TIMER OFF or TIMER ON-OFF). " "or " "will flash.
BLANK
TIMER ON TIMER OFF TIMER ON-OFF
TIMER OFF-ON
0.5h 0.5h 0.5h 0.5h
3.Press / button to set time.
It can be adjusted within 24 hours.
Hints:
After replacing batteries or a power failure happens, time
setting should be reset.
According to the Time setting sequence of TIMER ON or
TIMER OFF, either Start-Stop or Stop-Start can be achieved.
Press the button for each time, setting time in the first
12 hours increased by 0.5 hour every time, after 12
hours,increased by 1 hour every time.
Press the button for each time, settiing time in the first
12 hours decreased by 0.5 hour every time, after 12
hours,decreased by 1 hour every time.
After adjust the time,press button and confirm the
time ON or OFF button will not flash any more.
4.Confirm timer setting
5.Cancel timer setting
Press the timer button by times until the time display
eliminated.
9 Louver SWING Button
Press button ,the remote controller will show ,
and then achieve to the sleep function.
Press again this button , the sleep function will be
cancelled.
11
SLEEP Button
SLEEP
SLEEP
SLEEP operation starts SLEEP operation stops
Approx.6hrs
1 hr Rises 2 O F
Rises 2
O
F
Temp.setting
Unit stop
In COOL, D RY mode
1 hr
Sleep Operation Mode
1. SLEEP mode during C OOL, DRY modes
One hour after SLEEP mode starts , the temperature will
rise 2°F ab ove set temperat ure, after another hour , the
temperature rises an additional 2°F. The unit will run for an
additional six hours , then turns The temperature
is 4°F higher than the initial set temperature. Using this
feature will help with achi eving maximum and
c omfort from your unit while you sleep.