HEC AS09TB1HRH, User Manual

Page: 4 / 8

CONTROLLER FEATURES & SETTINGS PAGE 4
ENGLISH
12 EXTRA FUNCTION Button
Function:
SLEEP
operation starts
SLEEP
operation stops
1 hr
1 hr
3 hrs
3 hrs
Rises 2 O F
Temp.setting
Unit stop
In HEAT mode
Decreases 4
O
F
Decreases 4
O
F
A)HEALTH Operation
Feature not available on this series even display the icon
on the remote.
2. SLEEP mode during HEAT mode
One hour after SLEEP mode starts, the temperature will
decrease 4°F below set temperature, after another hour,
the temperature will decrease an additional 4°F. After an
additional three hours, the temperature will rise by 2°F.
The unit will run for an additional three hours, then turns
The temperature is 6°F lower than the initial set
temperature. Using this feature will help with achieving
maximum
and comfort from your unit while you
sleep.
3. In AUTO mode
The unit operates in corresponding sleep mode adapted
to the automatically selected operation mode.
Note:
-When the unit is set to sleep mode, the fan speed will be
set to low speed and cannot be changed.
-When the TIMER function is set, the sleeping function
cannot be set. If the sleeping function has been set, and
the user sets the TIMER function, the sleeping function
will be canceled, and the unit will be set to the timer
function.
B) Fan Mode - Is indicated by the
icon. Only the fan will
operate in this mode. See section 8 “FAN Button” for
changing the fan settings.
1. Setting the intelligent function
Press the EXTRA FUNCTION button to enter ad-
ditional options. Press this button repeatedly to access
the louver settings. The louver icon will cycle through the
C) Select the desired operating mode
Select the desired position, then press the CONFIRM/
CANCEL
button to set the function.
2. Canceling the intelligent function
Press the EXTRA FUNCTION button to enter addi-
tional options. Press this button repeatedly to access the
louver settings. Cycle the button to the louver icon “pres-
ent” position, then press the CONFIRM/CANCEL
button to cancel the function.
Notice: Do not reposition the horizontal louver by hand.
This may cause the louver to run incorrectly and not
match the icon displayed on the remote control. If the
louver is not running correctly, turn the unit
for one
minute, then back on, and adjust the louver setting with
the remote control.
Note:
1. After setting the intelligent
function, the louver
position is
2. In cooling, it is better to select the
mode.
3. In heating, it is better to select the mode.
4. In cooling and dry modes, using the air conditioner for a
long period of
time under high humidity conditions, con-
densate water may form on the grille/louver.
D) Right and Left Air fl ow Setting
Feature not available on this series even display the icon
on the remote.
E) A-B Yard - This will allow you to control two seperate units
with a single remote control.
Note: this feature would be setup at the time of installation
by the contractor.
F) 50°F low temperature heating
G) Refresh air - Feature not available on this series.even
display the icon on the remote.
H) QUIET-Available only in cooling or heating model.and display
the icon on the remote.
I) Fahrenheit/Celsius mode shift on unit and remote -
To switch between Fahrenheit and Celsius press the EXTRA
FUNCTION
button until either Celsius or Fahrenheit
is displayed. Press the CONFIRM/CANCEL button to
apply the change.
following three settings.
Healthy
airflow
upward
Healthy
airflow
downward
Present
position