10
9
Wireless
Series
Model:
DT-WTS
To pair the thermostat with the RC1-WTS receiver, follow these steps.
On the receiver;
Press the Pair button once.
The Communication LED will light up.
On the thermostat;
•
Press PROG and then SETUP ...................................................................................
•
At the top of the LCD, you will see 01.
•
Use the Up key to select 05 and enter the pairing function .....................................
•
Press Zone 1 or Zone 2 to select the relevant zone .......................................
(Two DT-WTS can work with a single receiver, offering a two zone system)
•
In the centre of the LCD, you will see 01. This is the channel address.
The default setting of 01 can be used in most cases, but should be changed when
a conflict is detected with other RF devices.
•
Use the Up/Down keys to enter the address ......................................................
•
Press SETUP to Pair the thermostat and receiver ........................................................
Note:
You must finish pairing the thermostat before the communication LED goes out.
Pairing the Thermostat
Pair Successful
The Comms LED on the receiver should flash and then go out to indicate
the pair is successful. The thermostat will display the communication icon.
Pair Fail
If the Comms LED does not flash there is a problem with the RF signal and
you should reduce the distance between the thermostat and receiver.
Where possible ensure there are no metal objects blocking the signal.
The LED will automatically go out after 1 minute.
Comms LED
