___________________________________________________________________________________________________________
P/N 900261-00 Rev. A REV 3/18/14 Page 1 of 5
IHP: WS-S-TSTAT
Cat. No. H8864
Model: WS-S-TSTAT
INSTALLATION AND OPERATION INSTRUCTIONS
INTRODUCTION
This WS-S-TSTAT wired wall thermostat was developed to provide a safe, reliable control system for gas heating appliances. The
system can be operated thermostatically or manually from the wall unit.
WALL MOUNT THERMOSTAT
The WS-S-TSTAT wired thermostat operates on (2) 3V Button Cell (Included) which powers the
LCD screen and circuit board. Before using the WS-S-TSTAT wall thermostat the 3V batteries must
be installed into the battery compartments.
It is recommended that CR2032 lithium batteries always be used for longer battery life and
maximum operational performance. If the LCD screen will not come on, check the 3V Button Cell
battery.
TO INSTALL BATTERIES IN THE THERMOSTAT
1. Remove face from backing wall plate this is done by sliding the face up about 1/2” then pull the face off the base plate. As
shown in Figure #1
2. Locate the (2) holders for the 3V button cell batteries.
3. Slide the button cell batteries into the battery holders. (Make sure that the batteries are installed with the (+) plus side facing
you or up.
4. Reinstall the face to the backing plate this is done by sliding the face in and down about 1/2” then check that the (2) male
terminal connectors on the face are engaged in the female terminal connectors on the backing plate. As show in Figure #1
TO REMOVE THE BATTERIES FROM THE THERMOSTAT
1. Remove face from backing plate
this is done by sliding the face up about 1/2” then pull the face off the base plate. As shown in
Figure #1
2. Locate the (2) holders for the 3V button cell batteries.
3.
Insert a small screwdriver into the slot above the button cell battery and push the battery out. As shown in
Figure #2
4. Reinstall the face to the backing plate this is done by sliding the face in and down about 1/2” then check that the (2) male
terminal connectors on the face are engaged in the female terminal connectors on the backing plate. As show in Figure #1
Figure #2
IF YOU CANNOT READ OR UNDERSTAND THESE INSTALLATION INSTRUCTIONS DO NOT
ATTEMPT TO INSTALL OR OPERATE
ON
OFF
SET
°
)
ROOM “SET” TEMP
LCD
Display
Thermo
Mode
SET Button
ON/UP
Button
DOWN/OFF
Button
(2) 3 Volt Button
Cell Batteries
Battery Removal
Slots
+
Plus
Side
+
Plus
Side
Figure #1
