Heat & Glo • CFL-30NG/LP, CFL-30NG/LP-B, CFL-30NG/LP-C • 526-925 Rev. E • 9/21
2
LOG # 7: (SRV446-702)
Set log #7 on the top of log #2 to the right (use flat area).
The pointed end should run toward the center of the
burner, and should rest underneath the pointed end of
log #6. Tilt up log #6 to accommodate the placement of
log #7. Make sure that the log will clear the ports on the
top of the burner.
FLAT AREAS (For log #8)
LOG #10: (SRV446-706)
Hold log #10 with bark detail towards the top and the
burned area towards the right. Set the back end of the log
on the left flat area located on the top of log #5. Rest the
front end of the log on the top flat area of log #6.
LOG #9: (SRV446-705)
Hold log #9 with the forked end towards the front and the
bark detail towards the top. Set the front end on the flat area
of log #2 towards the right, then lay the back end down to
overlap the flat area of the back corner of log #8.
LOG #8: (SRV481-704)
Hold log #8 with the bark detail towards the left. Lay the
back end of this log on the right flat area located on the
top of the back log. Rest the front end of this log on the flat
area to the left of the burned area of log #1.
FLAT AREAS
(For log #9)
LOG #11: (SRV530-703)
Hold this log with the bark detail to the right and the burned
area to the left. Set this log onto log #2 and lay it towards
log #5, outside the burner area to the right. The purpose
of this log is to cover the pilot.
FLAT AREAS (For log #10)
11
11
10
10
99
88
77
