Heat & Glo • CFL-30NG/LP, CFL-30NG/LP-B, CFL-30NG/LP-C • 526-925 Rev. E • 9/21
1
LOG PLACEMENT
INSTRUCTIONS
Log Set Assembly:
Models: CFL-30NG/LP
CFL-30NG/LP-B
CFL-30NG/LP-C
NOTE:
Following the instructions given below is very
important. Use the “flat areas” indicated in the photos to
guide you through the process. Use the log numbers to
identify the logs. Check to make sure the tabs on side
of the burner legs are bent outward. Set the log grate by
resting it down and sliding it toward the burner. Notice
that the burner styles may vary.
Make sure right and left grate bars slide on the outside of
burner legs between the tabs. Place “dime size” pieces
of mineral wool on top of the burner, spaced a dime’s
width apart.
LOG #1 & #2: (SRV526-766)
Set log #1 & #2 in front of burner. Rest the bottom two
notches over the extended material of the burner legs.
Slide it towards the burner until it comes in contact with
the burner.
LOG #3 & #4: (SRV526-755)
Set log #3 between the grate and log # 1 with the bark detail
towards the outside. Log #4 should be even with log #2 from
one side to the other. Slide grate to hold log in place.
33
11
88
10
10
66
44
77
22
99
55
11
11
11
22
33
44
BRACKETS
(Use to place log #5)
LOG #6: (SRV481-705)
Set log #6 on the top of log #1 and the burner towards the
left by following the flat area mark (on log #1). Make sure
that the log will clear the ports on the top of the burner.
LOG #5: (SRV526-701)
This log sits towards the back on the top of the brackets
located on the right and the left. The two notches on the
bottom of the log should rest over these brackets. The
back of this log should line up with the back end of the
brackets.
FLAT AREA(Use to place log #6)
55
FLAT AREA (For log #7)
66
CAUTION:
Carefully remove the logs from the
packaging. Logs are fragile!
BURNER STYLE MAY VARY
