2
598-1345-01
INSTALLATION
This model Instant Motion Sensor Light Control can be
used with many indoor or outdoor light fixtures where
the motion sensing feature is desired.
❒
Open the light fixture if it
is necessary. Remove the
light bulb. Screw in the lamp
module and replace the
bulb.
NOTE: Do not stretch the coils too tight when installing
the remote sensor. The coils are needed to create a
drip loop to prevent water from running into the fixture
or the sensor.
Keep the lamp at least 1"
(25mm) from the sensor
and cord.
WARNING: Risk of fire. Do not aim the lamps
at a combustible surface within 3 ft. (1 m).
Move ON-TIME Switch
to 1, 5, or 10 minutes
Mode Switching Summary
Flip switch off for
one second then
back on*
* If you get confused while switching modes, turn the power
off for one minute, then back on. After the calibration
time (1
1
/
2
min.) the control will be in the AUTO mode.
MANUAL MODE
AUTO
TEST
WARNING: Turn power off at circuit breaker
or fuse.
