2
598-1315-02
INSTALLATION
For easy installation, select an existing light operated
by a wall switch for replacement.
For best performance, mount the fixture about 8 ft. (2.4
m) above the ground.
NOTE: If fixture is mounted higher
than 8 ft. (2.4 m), aiming the sensor down will reduce
coverage distance.
CAUTION: Keep the sensor at least 2" (51 mm)
away from the lamps.
CAUTION: To Avoid Fire Or Burn Hazards:
• Allow fixture to cool before touching. The bulb and the
fixture operate at high temperatures.
• Keep fixture at least 2" (51 mm) from combustible ma-
terials. Do not aim at objects closer than 3 feet. (1 m).
• Use only T4, 100W (max.) G8 bi-pin tungsten halogen
120 VAC lamps.
For eave mount only:
For under eave installation, the sensor head must
be rotated as shown in the next two steps for proper
operation and to avoid the risk of electrical shock.
Also
for proper under eave operation, remove the
protective backing from the light shield and stick on as
shown below.
MANUAL MODE
... back on.
1 Second OFF
then...
Move ON-TIME Switch to
1, 5, or 20 minutes
Mode Switching Summary
Flip light switch
off for one second
then back on*
MANUAL MODE
AUTO
TEST
Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one second
then back on to toggle between AUTO
and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or 20
position.
* If you get confused while switching modes, turn the
power off for one minute, then back on. After the cali-
bration time the control will be in the AUTO mode.
ON-TIME
RANGE
DU
AL BRIT
E™
MIN
MAX
TE
ST 1
5
20
MI
NUTE
S
OFF 3
6 DUS
K TO
H
OUR
DAWN
LA
MP
MOD
E
NO
RMAL S
OFT FL
ASH
❒
Swing the sensor head towards the clamp screw
joint.
If the sensor pops out of the ball joint, loosen the
clamp screw and push the sensor back into the ball
joint. Tighten the clamp screw when done.
❒
Then rotate the sensor head clockwise 180° so the
controls face down.
Controls
Controls
Controls
Clamp Screw
D
ual
B
rite
®
Timer
Light comes on half bright for selected time after dusk
(Off, 3 hr., 6 hr., until dawn). Selecting OFF disables
this feature. The motion sensing features will continue
to work as described in this manual. If motion is sensed,
the light turns on full bright for the ON-TIME (1, 5, or
20 minutes) then returns to dim mode.
Lamp Modes
There are three lamp modes (light turn-on effects) avail-
able when motion is detected:
•
NORMAL - Light instantly comes on.
•
SOFT - Light starts dim and gradually increases to
full brightness. Light gradually dims to half-bright,
pauses, and then continues dimming to off when
motion is no longer detected and after selected ON-
TIME.
•
FLASH - Light flashes on then off twice before turn-
ing on full brightness.
Light Shield
Opening
