3
598-1315-02
Mount the Light Control
❒
Place the mounting bolt through the front of the
junction box cover. Push the small gasket hole over
the mounting screw.
❒
Make sure the wire connectors and wires are inside
the junction box. Align the mounting screw with the
center hole in the mounting strap. Secure the fixture
to the mounting strap.
❒
Push the rubber plug firmly into place.
❒
If not installed on a weatherproof box,
caulk the
wall plate and mounting surface with silicone.
❒
Adjust the lamp holders by loosening the lock nuts
but do not rotate the lamp holders more than 180°
from the factory setting.
❒
Adjust lamp shades by loosening the set screws
several turns, turn shades counterclockwise and
remove. Reinstall the shades in the desired position
and tighten set screws.
Keep lamps at
least 2" (51 mm)
from the sensor.
Wire the Light Control
Push the Rubber Plug
over the Mounting Screw.
WARNING: Turn power off at circuit breaker
or fuse.
❒
Remove the existing light fixture.
❒
Install mounting strap to junction box using screws
appropriate for your junction box.
❒
The plastic hanger can be used to hold the fixture
while wiring. The small end of the plastic hanger
can be threaded through the hole in the center of
the cover plate. The small end then goes into one
of the slots on the mounting strap.
❒
Thread all fixture wires through the large holes in
the gasket as shown.
❒
Connect the junction box wires to the light fixture
wires as shown. Twist together and secure with
wire connectors.
Bulb Installation
NOTE: When re-lamping, turn power off and let the
fixture cool.
❒
To remove lamp shade, loosen set screw 2 full
turns with a small flat-head screwdriver. Turn shade
counterclockwise and remove.
❒
To remove bulb, pull straight out of fixture.
❒
To replace bulb, firmly push bulb pins into lamp
socket until completely seated.
❒
To reinstall lamp shade, place shade on fixture and
align notches on shade with tabs on fixture. Turn
clockwise. Tighten set screw firmly.
Lock Nuts
Lens
Lamp Shade
Set Screw
White to White
Black to Black
Junction box ground wire to
green ground screw on fixture.
Gasket
Mounting Strap
Mounting
Bolt
Rubber
Plug
