15
FIGURE 15
2.4
FAN OPERATION
The accessory fan is wired in series with a speed con-
trol switch and a temperature sensor switch. Set the
speed control to an "ON" position and light the heater.
The temperature sensor switch will automatically start
the fan when the switch warms up—and stop the fan
when it cools down. You can manually stop the fan by
turning the speed control switch to "OFF". See Figure
15 for fan wiring diagram.
3.0
SERVICING AND MAINTENANCE
A. HEATER SERVICING: Frequency of heater servic-
ing will depend upon use and type of installation.
B. IMPORTANT: TURN OFF GAS BEFORE SERVIC-
ING APPLIANCE. IT IS RECOMMENDED THAT A
COMPETENT SERVICE TECHNICIAN PERFORM
SERVICE CHECK-UPS AT THE BEGINNING OF
EACH HEATING SEASON.
C. The appliance and flue system should be inspected
before initial use and at least annually by a quali-
fied field service person.
D. Inspect the external flue cap on a regular basis to
make sure that no debris is interfering with the air
flow.
E. Keep the control compartment, logs, and burner
area surround the logs clean by vacuuming or brush-
ing at least twice a year.
CAUTION:
THE LOGS GET VERY HOT - HANDLE
ONLY WHEN COOL.
Summary of Contents for ATS-AUST
Page 4: ...3 FIGURE 1...
Page 7: ...6 FIGURE 4 FIGURE 5...