34
Heat & Glo • SL-550TRSI-AUE • 2079-902 Rev. K • 10/08
PILOT BRACKET
RETAINING SCREWS
3.1 REMOVAL OF COVERS FOR SERVIC-
ING
A. Control Compartment Door
• Rotate the lower door down to access the gas con-
trols.
B. Dress Guard and Glass Door
• Lift the front dress guard up and out away from the
appliance side surrounds. Replace the dress guard
when servicing is complete.
• Release the four glass clips around the glass door.
Carefully lift the glass up and out away from the ap-
pliance (see Figure 49).
Figure 49. Glass Assembly
Figure 50.
LATCHES
(BOTH TOP
AND BOTTOM)
GLASS
ASSEMBLY
CAUTION:
ALL SCREWS WHICH WERE RE-
MOVED MUST BE REPLACED.
2. PILOT ASSEMBLY/IGNITION SYSTEM
• Remove the log set, log grate, metal base pan and
burner.
• Disconnect the gas supply tube from the underside
of the gas valve and the thermocouple from the inter-
ruptor block.
• Disconnect and remove the pilot assembly from the
bracket.
NOTE:
When removing the pilot assembly, carefully
pull the electrode wire, detach from the assembly and
leave in place for reconnection.
3.3 PARTS REPLACEMENT
1. FAN/SWITCHES
• Disconnect the fan wires from the junction box wires
by pulling the male and female connectors apart
and slide the fan out the front of the lower controls
compartment.
• Disconnect the wires from the fan speed control
switch, pull off the knob, and remove the nut holding
the speed control to the bracket.
• Disconnect the wires from the fan temperature sen-
sor switch and remove the nut holding the switch
bracket onto the side of the fi rebox.
2. GLASS PANEL
• To replace the glass door, place the bottom edge
on top of the bottom mounting brackets. Push glass
against unit and latch the two fasteners at the top of
the glass door and the two fasteners at the bottom
(see Figure 49).
3.4 ADJUSTMENTS AND REPLACEMENT
PARTS
Adjustments and replacement parts for this appliance
should only be done by a qualifi ed service person. A
wiring diagram for the appliance is shown in
SECTION
2.0 OPERATING INSTRUCTIONS
. A replacement part
table is shown in
SECTION 4.0
of this manual.
3.2 REMOVAL OF COMPONENTS FOR
SERVICE
1. BURNER
• Carefully remove the log set. Remove the rear
screws holding the log grate. Remove log grate and
metal base pan.
• Unscrew the brackets at both ends of the burner and
the retaining screws at the pilot bracket (see Figure
50). Slide the burner towards the right away from the
burner orifi ce.
