Heat & Glo • 6000CBV-IPI, 8000CBV-IPI • 2167-900 Rev. C • 9/09
33
Figure 13.4 Finishing Material 1 Inch Thick or Less
DOOR
1 in. MAX.
FINISHING MATERIAL
(TOP EDGE)
Finishing materials 1 inch maximum thick.
Stop fi nishing material fl ush with opening.
FINISHING STRIP NOT USED
NON-COMBUSTIBLE
FINISHING MATERIAL
C. Doors
Only doors certifi ed for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used. Once you have determined what kind of door
and fi nishing material is going to be used on the fi replace,
you may use the table below which shows the door mod-
els and the fi nishing material thickness allowed.
NOTICE: See service parts list (Section 16.B) for ordering
fi nishing strips.
DOOR
FIT
FINISH MATERIAL
THICKNESS
SEE
FIGURE
Folio
Inside
Any
13.6
Arcadia
Overlap
1 inch or less
13.4
Inside
Greater than 1 inch
13.5
Halston
Overlap
1 inch or less
13.4
Inside
Greater than 1 inch
13.5
Chateau
Overlap
1 inch or less
13.4
Inside
Greater than 1 inch
13.5
Galleria
Overlap
1 inch or less
13.4
Inside
Greater than 1 inch
13.5
Finishing Material Thickness:
1 Inch Thick or Less
Note:
Finishing strips may be used to aid in posi-
tioning of non-combustible facing materials for some
of the facing and door combinations specifi ed in the
table above. They must be removed following fi nishing
work. See fi gure 13.7.
f i r e - p a r t s . c o m
