14
Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors.
Tighten strain relief screws to secure cord.
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use
¹⁄
" nut driver or Torx
®
T20
®
screwdriver
and previously removed screw to secure cover.
NOTE:
Do not plug into outlet until instructed to do so.
Determine Cabinet Opening
Measure height of cabinet opening from underside of countertop
to
where dishwasher will be installed (you will need to
measure the lowest point on the underside of the countertop and
the highest point on the oor). Refer to “Dishwasher Height
Adjustment Chart” for wheel position and the number of turns
needed.
NOTE:
If the minimum cabinet opening height is less than
34" (86.4 cm), the rear wheels can be removed for additional
clearance. This will allow the dishwasher to t into a 33
¹
"
(85.1 cm) high cabinet opening, but the dishwasher will be more
di cult to move. (Measurements are approximate. Wheels and
legs are preset at the factory for 34
¹⁄
" [87.6 cm].)
Turn both leveler legs to the same height. Put wheels in the
required position determined from “Dishwasher Height
Adjustment Chart.”
