Hearthstone Quality Home Heating Products, Inc.
DVI-44 Model 8860
29
Baffle, Log Set, & Screen Placement
CAUTION: FRAGILE! HANDLE LOG SET WITH
CARE. ALWAYS WEAR GLOVES AND SAFETY
GOGGLES WHILE HANDLING THE LOG SET.
WARNING: FAILURE TO POSITION THE BURNER
AND LOGS IN ACCORDANCE WITH THESE
DIAGRAMS OR FAILURE TO USE ONLY PARTS
SPECIFICALLY
APPROVED
WITH
THIS
APPLIANCE
MAY
RESULT
IN
PROPERTY
DAMAGE OR PERSONAL INJURY.
Place only the ceramic baffle and log sets supplied
with the unit in the firebox. Do not place any other
ceramic logs, wood logs, or other materials in the
firebox. If the ceramic baffle or log set is damaged
or broken contact your dealer for replacement. The
baffle and ceramic logs will last a long time;
however, they will break if subjected to rough or
improper handling.
Exact positioning of the baffle and log set is
required in order to obtain a pleasing flame
pattern and efficient combustion.
Incorrect log
placement may cause carbon build-up; excess
thermal stress on the log set and stove parts,
reduced efficiency, and produce dirty emissions. If
the log set does not fit into the firebox exactly as
outlined, contact your dealer for assistance.
Installation of the Baffle
1. Refer to the firebox access procedure outlined
on page 188 if not already opened.
2. The ceramic burner is factory installed. Removal
is recommended, but not necessary for baffle
component installation.
3. Remove the packaging material around the
baffle set assembly. Be careful not to damage
the baffle set when unpacking. Place the rear
baffle panel in the back of the firebox on the
baffle support as shown.
Photo 1 - Rear Baffle
(burner removed for clarity)
4. Next, install the left baffle panel against the left
firebox side. To allow the left panel to clear the
burner, slide the rear baffle panel rearward and
lift it slightly. Insert the bottom edge of the left
panel into the space between the burner and
firebox. Rotate the panel until it is vertical and
the top edge matches the mating edge of the
rear panel. Slide the rear panel down to fit in
place.
Photo 2 - Left Baffle Panel
5. Next, install the right baffle panel against the
right side wall of the firebox as shown. The right
side is made up of two parts. First, place the
small part in the front right corner. Be sure to
put the end with the key feature facing up. Slide
the rear baffle panel rearward and lift it slightly.
Place the large side panel so it is supported in
the front by the small part. Slide the rear panel
down and forward to secure the panels in place.
Photo 3 - Right Baffle Panel
6.
Adjust the baffle panels as necessary for a tight
fit.
