3
598-1160-05
1
2
Mount the Light Control
1. Place the mounting bolt through the front of the
junction box cover. Push the small gasket hole over
the mounting screw.
2. Make sure the wire connectors and wires are inside
the junction box. Align the mounting screw with the
center hole in the mounting strap. Secure the fixture
to the mounting strap.
3. Push the rubber plug firmly into place.
4. If not installed on a weatherproof box,
caulk the
wall plate and mounting surface with silicone.
5. Adjust the lamp heads by loosening the lock nuts
but do not rotate the lamp heads more than 180°
from the factory setting. The locking screw should be
on top and the lamp heads should be horizontal.
Keep lamp heads at least 1"
(25 mm) from the sensor.
Wire the Light Control
Bulb Installation and Replacement
Push the rubber plug
over the mounting screw.
Locking Screw
Left
Socket
Right
Socket
Contact
Bulb
Lamp Head
Glass
Cover
White to
White
Black to
Black
Gasket
Mounting
Strap
Mounting
Bolt
Rubber
Plug
Connect any fixture ground wire(s) and the cover
plate ground screw to the junction box ground
wire.
WARNING: Turn power off at circuit breaker or
fuse. Place tape over circuit breaker switch and
verify power is off at the fixture.
CAUTION: When replacing bulbs, turn power
off and let the fixture cool.
1. Remove the existing light fixture.
2. Install mounting strap to junction box using screws
appropriate for your junction box.
3. The plastic hanger can be used to hold the fixture
while wiring. The small end of the plastic hanger
can be threaded through the hole in the center of
the cover plate. The small end then goes into one
of the slots on the mounting strap.
4. Thread all fixture wires through the large holes in
the gasket as shown.
NOTE: Bulbs are included, but need to be installed.
The bulbs are located behind the glass cover of
each lamp head.
Use a clean glove or cloth when handling the new bulb.
Use isopropyl (rubbing) alcohol to clean the bulb if it is
touched with your bare hands.
1. Open lamp head with a phillips head screwdriver.
To remove the old bulb, push the bulb towards the
right until the left side of the bulb is clear of the left
socket.
2. To install the bulb, place one end of the bulb on the
contact in the right socket. While pushing the bulb
against the right contact, lower the other end of the
bulb onto the contact in the left socket.
3. Spin the bulb to verify it is seated properly.
4. Close the lamp head and tighten locking screw
securely.
5. Connect the junction box wires to the light fixture
wires as shown. Twist together and secure with
wire connectors.
