HDPlex Passive NUC Kit Installation Quick Manual Download Page 6

Page: 6 / 6

Install the PCIE Riser cable (M.2 to PCIE riser cable is not included in the HDPLEX Passive NUC kit).

Since M.2 socket provides 3.3V only, for PCIE card which needs 5V, please use the FDD to SATA

power cable included with the M.2 to PCIE riser to get 5V from NUC SATA power output. If your PCIE

card needs 12VDC, you would need to find a 12VDC source. The fan connector on NUC board could

be a potential 12VDC source but it might only supports upto 0.5A.

Install SSD using H1 HDD rack. If H1 HDD rack does not align with its mounting hole on both side

panels, do the following:

A: Loosen the four M5 CUP Head HEX screws which attach the back plate to both side panels.

B: Loosen the eight CUP Head M3*10mm which attach the aluminum top plate to the NUC heatsink

copper base.

Then adjust/tilt both side panels until they align with the HDD rack.

If you are using HDPLEX internal 80W/200W ACDC adapter, please plug the 5.5/2.5mm male to

male cable.

Summary of Contents for Passive NUC Kit

Page 1: ...age The installation would require accessories from H1 fanless PC case installation kit as well Install the USB 3 0 Cable using M3 8mm screw from H1 PC case installation kit to the NUC I O plate If you are using HDPLEX internal 80W 200W AC DC power supply for NUC install the 6PIN Molex female to 5 5 2 5mm DC Jack self lock cable ...

Page 5: ...oth side panels using the dumbbell tool from the H1 installation kit Install six heatpipes and H 9 black plate to both side panels using H 4 M3 14mm screws from H1 CPU heatsink system to lock heatpipe to both side panels Install the aluminum top plate using four A CUP head HEX M3 10mm screws ...