15
1
Ensure that audio source devices are off.
2 Connect audio inputs to MHUB AUDIO .
3
Connect MHUB AUDIO outputs or sub/slave ports to speakers or amplifiers.
4
Connect an Ethernet cable between your router and the IP control port.
5
Connect the power cable to MHUB AUDIO - the MHUB will turn on.
6
Turn on any audio source devices
7
MHUB AUDIO will begin to boot up, this can take 60 seconds. uControl will not
find MHUB AUDIO until this period has passed.
8
Load uControl
9
Complete setup on uControl (see “Setup on uControl”)
Power up
Standalone setup example
Listen to anything everywhere
In the diagram (“Setup: wiring for operation in standalone mode”) we have
demonstrated a typical setup where MHUB AUDIO might be used to provide music
and audio in a restaurant location. MHUB AUDIO is being used to power 16 speakers
in total using a method of wiring called Parallel Connectivity. There are also four
active subwoofers (#1) providing full-range, high quality audio in each one of the
defined zones, “Reception”, “Drinks”, “Upstairs Dining and “Downstairs Dining”.
Full control over audio routing
In this example, the music streaming device is being used to route audio to the
dining areas. In the bar, staff are allowed to connect their own devices and play the
music that they like. For times when a pre-defined playlist is required then there is a
PC which can have music loaded on to it. At any time, all zones can switch in to any
input by using uControl or a control system.
Note:
MHUB AUDIO has been designed so that it can be installed in several
different ways. The purpose of the diagram is to illustrate a typical setup
and assumes that you are already familiar with the basics of audio wiring
and infrastructure. If you are unsure how you might install MHUB AUDIO in to
your property then contact [email protected] for further assistance.
Summary of Contents for MHUB
