Help is only an email away:
.
10
MHUB control methods
MHUB AUDIO has been designed to be operated and controlled in numerous ways depending on your requirements. There are no control buttons on the front of the MHUB
AUDIO (see MHUB AUDIO (6x4) Front Panel). This MHUB has been designed to be located centrally and its control methods are primarily those which do not require line of
sight to the unit. The methods to control MHUB AUDIO and considerations for each are listed below.
uControl
Available on iOS and Android, uControl is MHUB AUDIO’s native method of control. All of MHUB AUDIO’s built-in features are available; offering comprehensive control over
switching, volume, grouping, executing Sequences and mute states in all zones. uControl communicates over the same Local Area Network (LAN) as your MHUB AUDIO
which allows for global control over the entire system regardless of what zone you are in.
Voice
All MHUB systems support voice control as standard via an Amazon Echo (Alexa) device. Voice control is not designed to act as a primary control method but to assist the
other methods listed on this page. Using voice it is possible to control volume adjustments (“set volume to 25%”), muting and switching input from any zone.
Third-party control system
Control via a third-party control system is also supported using our latest and most advanced API to date. For an up-to-date list of systems that MHUB AUDIO supports
please visit the “Control Drivers” section of our support site: http://support.hdanywhere.com. Control varies depending on the control system being used but typically,
switching, volume and mute control is supported.
MHUB-OS
Any device with a web browser can control MHUB AUDIO directly from the MHUB-OS dashboard. From here it is possible to control switching, volume and mute states.
MHUB-OS is also where all configuration for MHUB AUDIO can be done.
Infrared (IR)
This is a legacy method of control. If you would like to use IR as your control method then you will need to purchase an IR Receiver and configure your remote control device
to output MHUB AUDIO’s IR control commands. IR codes can be found on our support site: http://support.hdanywhere.com. This method of control requires line of sight with
the MHUB system as there is no way to send an IR command from any zone back to the MHUB device. HDANYWHERE’s recommendation is not to use this method other
than for testing the system should no LAN be present.
Summary of Contents for MHUB
