©HBS Bolzenschweiss-Systeme GmbH & Co. KG
All rights reserved – Reprinting, in whole or in part, only with the approval of the manufacturer
28
10 Preparing the Stud Welding Gun
Adjusting Lift
The adjustment piece for lift must not be turned by more than 360°.
1
2
3
4
5
1 - Cap
2 - Marking
3 - Scale wheel
4 - Slotted screw
5 - Allen key size 8
Screw off the cap (1) at the rear.
Use the allen key to turn the adjustment piece for lift counter-clockwise to the se-
lected lift
(see table under point 10.3)
.
The lift can be adjusted in steps of 0.25 mm. (The empty space between 0 and
0.25 mm serves to mechanically balance out the lifting ring construction).
Screw on the cap again.
You can
reduce
the lift by turning the adjustment piece for lift
clockwise
.
You can
increase
the lift by turning the adjustment piece for lift
counter-clockwise
.
Summary of Contents for 93-20-290C
Page 43: ......
