Sensor Installation
FS64
A4263-3.5
HBM: public
21
After unlocking the sensor in the front it is time to do it on
the side screws -
- (see number 3 on
).
On this direction the change in wavelengths should be
smaller. Nevertheless, the unscrewing should be per
formed in small steps and alternately as in the front
screws.
2.2.4
Vertically Aligning
Now it is time to set the final alignment of the sensor.
Ensure that the difference between the two central wave
lengths equals the one in the calibration sheet.
Information
If you have information on the tilt value, you should set it
as close as possible to zero.
Fig. 2.12
