18
Always wear personal protective clothing and safety equipment!
3
Design and Function
4. Application
Fixation of the rechargeable battery:
• Push battery in until it locks into place with a
“clic“-sound.
• If the battery has not locked into place it can
loosen from the tool and fall down being damaged
or hitting other persons.
• The battery pack has a state of charge display.
The „+“ button and 4-step LED‘s (green) indicate
remaining capacity status and over temperature
condition
• The green LEDs show the remaining capacity
and temperature protection status when the „+“
button is shortly pressed.
Capacity Indication
green leD
status
LED 1
0 - 25 %
LED 1, 2
26 - 50 %
LED 1, 2, 3
51 - 75 %
LED 1, 2, 3, 4
76 - 100 %
LED 1 blinking (0,25 sec)
Fully Depleted
LED 1, 2, 3, 4 blinking
(0,5 sec)
Over Temperature
condition
Detaching of the battery:
• Press safety-locking (blue) and pull battery from
the handle.
Prior to operation:
• Clean up work area.
• Keep trespassers out of the work area.
• The work place should be well lit and ventilated.
• Make sure that the rechargeable battery is in-
serted correctly and has locked into place.
Adjusting the sense of rotation:
• The sense of rotation is adjusted with the inverse
button.
Attention
While the tool is in operation, the sense
of rotation cannot be changed. In or
der to change the sense of rota tion,
the impact wrench has to be stopped
and then you can push the button for
changing the sense of rotation.
Operation
• Press trigger for tool operation.
• Release trigger to stop tool operation.
• With the operation trigger the speed/number of
revolutions can be adjusted continuously. Press
trigger slightly for low speed/number of revolu-
tions, press it stronger for high speed/number of
revolutions.
note:
• Loud operation noise!
• Wear ear protection!
tightening and loosening screws:
• For tightening and loosening screws, choose a
socket fitting the screw.
Attention
Avoid too long screwtightening, the
screw may be tightened too much and
could break.
• When tightening screws with the impact wrench,
always hold it in a right angle to the screw.
• If the impact wrench is fitted at an angle, the
screw’s head might be damaged and the force
will not be transmitted onto the screw.
